The 12" x 12" continues the rustic stone look of the
other products in the Halifax® Flagstone line. Palletized separately, it can be laid alone or combined with the
Halifax® Flagstone Mixed, allowing different designs of various scales. The 12" x 12" can also
be used as a border for either the Halifax® Flagstone Mixed or Irregular.
Colors: Chocolate/Tan Blend, Gettysburg Gray, and
South Mountain Sand
Halifax®
Flagstone
Mixed |
Thickness |
pcs
per
s.f. |
s.f.
per
strap |
pcs
per
cube |
s.f.
per
cube |
s.f.
per
truck |
lbs
per
cube |
| 12" x 12" * |
3" |
1 |
24 |
96 |
96 |
1344 |
3102 |
| 8" x 12" (A)
8" x 8" (B)
4" x 8" (C)
|
3" |
— |
— |
64 (A)
64 (B)
64 (C)
————
192 |
85.33 |
1365.28 |
2720 |
Sizes shown are nominal. Products are made to fit metric modules.
* The 12" x 12" size is packaged seperately.
Please note: Before ordering, make sure you have selected the correct proportion of 12" x 12"
pieces according to the effect you wish to achieve. For ease of installation, it may be necessary to cut the 4"
x 8" piece in half to fill spaces which the laying design created. Hand spacing of the half piece
may be needed to maintain joint alignment.
Pavers with profiled tops are most
susceptible to harm from plate compactors. These pavers have high and low points molded into the
surface, which prevent the equipment from riding flat and subject the high points to potential
scuffs. However, even smooth, flat surfaces can be harmed with improper usage or the existence
of debris on the plate. To help minimize the scuffing of the profiled surface, it is important to have
adequate sand on the surface prior to tamping. Hanover® recommends the use of a plate tamper
with a rubber mat attachment.
Before ordering make sure you have selected the correct
proportion of 12" x 12" pieces according to the effect you wish to achieve. For ease of
installation, it may be necessary to cut the 4" x 8" piece in half to fill spaces which the
laying design created. Hand spacing of the half piece may be needed to maintain joint alignment.
Joints must be filled with polymeric sand which is specially formulated for the filling of wide joints
when installing pavers. Unlike traditional sand, polymeric sand stays in place and remains stable;
effectively resisting erosion caused by water, frost, wind, etc. |
|
